Betrayal at Hill House

[Skip Nicholson]

Hey guys, when you say "warping" what do you mean? Are the figures bent over or something? I am very interested in this game but an unfamiliar with it other than what I have read on-line.

Here's a tip.

If thefigures are bent or slanted, have you tried the "fire and ice" method for straightening them out?

Just in case you are not familiar. Take a pan of water and bring it to a boil. Drop the bent, twisted, warped figure into the water. Literally in just a few seconds you should see the figure "straighten up" as the mold memory of the plastic kicks in. If it doesn't straighten to your satisfaction use some tongs or chopsticks to remove the figure from the hot water. Quickly reposition the figure the way you want it and dip it into a bowl of ice water. Hold it there for a few seconds and then set it out on a paper towel to dry. The mold memory should cause the figure to straighten up and the cold water will "set" the figure in the new position.

I have used this method on HUNDREDS of soft plastic figures over the years and it works 90% of the time. I have even done it with painted figures and did not experience any paint loss.

You might give it a try.